New 3D Printed and Acrylic MiSTer Cases

MiSTeraddons.com has just launched new 3D printed cases, as well as acrylic cases.  The “V2” 3D printed case is available now for $35, plus $10 for the additional USB hub case.  It will be a few weeks until the acrylic cases are ready, but those will sell for $55.

It’s my personal opinion that a case is necessary, both as protection and to make the MiSTer easier to use;  I found it cumbersome trying to use it as a bare dev kit, but now it feels more like a real console that I’m comfortable sitting on a shelf.

More information can be found here:  https://misteraddons.com/something-old-something-new/

MakerSpot Micro USB OTG Hub for Raspberry Pi Zero 4 Port High Speed Sync and Extension Cable Adapter Also Works with Android Tablet Raspbian Jessie Linux

(721)

$7.99

Expands into 4 USB Ports for Raspberry Pi Zero v1.3 (with camera connector) and W (with Bluetooth and Wifii), Orange Pi, ODROID, Banana Pi Compatible with Samsung Galaxy S2, Samsung Galaxy Note, Samsung Galaxy S3/S4, Galaxy Tab3 8.0, Sony Xperla NX-0... read more

(as of November 19, 2024 12:24 GMT -05:00 - More infoProduct prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.)

DE10-Nano Kit

(205)

$299.95

110K LEs; 5570 Kbits Embedded Memory; 6 PLLs; 2 Hard Memory Controllers 800MHz Dual-core ARM Cortex-A9 Process; 1GB DDR3 SDRAM; 32-bit Data Bus 1 Gibabit Ethernet PHY; USB Micro-AB Connect; Mirco SD Card Socket Model Number : P0496

(as of November 18, 2024 22:37 GMT -05:00 - More infoProduct prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.)

Something Old, Something New

Proud to announce two new #MiSTer products: a revised 3D printed case and a brand new acrylic case! Both are in my store (https://t.co/9IjFih4RLf) now, though the acrylic case is a pre-order. Head on over to my site to read more:https://t.co/zljZV2C7O8 pic.twitter.com/7fsaqCzcRw

— Porkchop Express (@MisterAddons) March 7, 2019

Liked it? Take a second to support Bob on Patreon!