Low_budget has updated the Parsec Supergun, which brings a bunch of really nice upgrades and new design features:
The v1.1 PARSEC Supergun has the following Improvements over the v1.0 PCB:
- Thicker 1.5 oz copper layer
- Wider +5v traces can handle loads up to 15A
- 3 unused component footprints removed
- controller ports now even with board edge
- removed unsightly jumper wire to JAMMA connector (necessary on v1.0 because I forgot to connect video ground pin 14)
- test and service button locations swapped
- some improvements to component placement and footprint design
- connection points on PCB for A/V modification possibilities (such as adding RGB adjustment pots)
- it’s purple now
The v1.1 circuit is the same as v1.0 so no changes there.
The HAT board I’m making will work on both versions of the PARSEC.It will take me a while to assemble small quantities of v1.1 PARSEC systems and additional HAT boards.
I’ll need to order parts and set aside quite a bit of time, so this will be a while.
More pictures & information at https://www.arcade-projects.com/forums/index.php?thread/7765-parsec-supergun-project/&postID=126337#post126337