Retro-Access MiSTer SCART Cable

The MiSTer FPGA Multi-Console IO board add-on allows for zero-latency analog video output via a Dsub-15 port. This port can be used for virtually any analog signal (component, VGA, etc) including RGB.

While you could use a cheap, modified VGA-to-SCART cable, they are far from ideal in a lot of ways. To answer the demand for a high-quality SCART solution, Retro-Access has launched a custom cable tailored to MiSTer, priced currently at $42. Get it here.

This same cable could be made with BNC leads as well.

Retro-Access MiSTer SCART Cable Features

Cabling – Cable Length:

6 Ft (9)
Source Connector – Video Connector:

15 Pin Dsub (15)
Source Connector – 15 Pin Dsub Pinout:

RGBS
Source Connector – Pinout Notes:

VGA pin 9 is +5v attenuated with a 470 Ohm resistor. This is a cable for the MiSTer IO board. RGB are standard vga pinout and CS uses the H.Sync pin.
Source Connector – Audio Connector:

3.5mm Straight Plug (4)
Destination Pinout and Audio – Destination Pinout:

SCART
Destination Pinout and Audio – Destination Audio Connector:

Audio Line in SCART

#MiSTer, #scart, #retroaccess, #rgb